Circuit design - Category Home
Circuit design - Topics
What makes an inductor saturate and how do you size one for a buck converter?
How does process variation between neighboring transistors break analog matching?
When can a cheaper resistor be substituted without hurting reliability?
Ground plane splits: when do they help and when do they wreck EMI?
Why do decoupling capacitors have to sit so close to the pin?
Tantalum capacitors fail short — what does that mean for a design?
Why is analog IP so hard to port from one process node to another?
How do you keep a switching regulator from polluting a sensitive analog rail?
Resistor tolerance vs temperature coefficient: which one actually matters?
Class II ceramic capacitors lose capacitance under DC bias — how do you derate them?
How do you simulate a circuit when the device model itself is wrong?
Clock jitter budget: how much can each stage consume?
Ringing on a fast digital edge: terminate the trace or slow the edge?
Where does common-mode noise in a differential pair come from?
What makes RF board design fundamentally different from low-frequency design?
How do you test a mixed-signal board without an expensive bench?
Why does 50-ohm trace impedance matter and when does it not?
Why is analog layout still more craft than automation?
Dark silicon: why most of the transistors on a modern chip must stay switched off
Why does a breadboard prototype so often fail on the first PCB?