Holding tools - Topics
Jewelry pliers: why chain-nose and flat-nose are not interchangeable
How many sheets can one bulldog clip hold?
Bench vise height: the number most people mount wrong
Clamping a part at 0.01 mm without marking it
Three jaw or four jaw chuck for a beginner on the lathe?
Over-centre toggle clamps: what makes them hold with no power?
Locking pliers: the jobs a Vise Grip does better than a wrench
Helping hands vs a PCB vise for holding a board
Reverse-action tweezers for placing tiny rhinestones
Bench vise jaw width: how much is enough for real work?
Retractors: the assistant's hands matter as much as the instrument
Long reach needle nose pliers for hose clamps in tight spaces
Corner clamps for assembling a frame square
Combination pliers or lineman pliers for gripping and twisting wire?
How do you clamp an odd shaped part so it cannot move while you drill it?
Why needle holders have a ratchet and what the settings do
Keeping a part from lifting off the drill press table
Magnetic welding clamps: do they hold a joint square enough to tack?
Parallel clamps or F clamps for a panel glue up?
What is a mosquito forceps actually used for?
Do I need a stitching pony or can I just hold the piece?
Why does a drill press vise need to be bolted down?
Spring clamp or screw clamp holding power on thin stock
Bar clamp or pipe clamp for a wide glue up?
What size C clamp for pressing a bearing into a housing?
Soft jaws for a bench vise: when you actually need them