Machine tools - Topics
What speed should a drill press run for a 10 mm hole in mild steel?
Teaching a member to use a table saw is part of lending it
CNC tool holders need a numbering system before they need more shelves
Levelling a lathe and shimming the feet: why does it matter?
Collet chuck or drill chuck for holding an end mill?
Three jaw or four jaw chuck for a beginner on the lathe?
Why does my lathe leave a rippled chatter pattern on a finish pass?
Carbide inserts or high speed steel tool bits for a beginner?
Runout: tool holder vs collet vs the machine itself
Dado stack or router for cabinet shelf grooves? Which leaves cleaner plywood edges?
CNC router or router table for repeatable cabinet parts?
Moving a 400 kg lathe across a concrete floor
Never wear gloves at a drill press and that includes the thin ones
Cast iron tables rust overnight in an unheated shop
What relief angle should you grind on a lathe tool bit for aluminum?
At what point does a tool become a machine?
Tramming a milling head: how square is square enough?
Keeping a part from lifting off the drill press table
Did machine tools deskill the machinist or raise what the trade demanded
What spindle speed for a 6 mm end mill in mild steel?
A precision vise spec: repeatability beats jaw flatness
Why does a drill press vise need to be bolted down?
Jointer setup: getting the infeed and outfeed tables coplanar with a straightedge
A ring caught on a spinning arbor turns a small snag into an amputation
Ball screw versus lead screw: efficiency and backlash in a linear axis
Choosing a bandsaw: resaw capacity matters more than motor size for veneer work
Converting a manual mill to CNC: what actually has to be replaced?
Buying a used lathe: which wear points should you check before paying?
Hand tapping or spiral flute tap in a drill press?
Why does a benchtop lathe stall on a light cut in steel?
Dial test indicator or edge finder for picking up a workpiece edge?
Moving a 900 kg lathe into a home garage workshop